TANDBERG Security Camera Security Camera User Manual


  Open as PDF
of 247
 
170
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Conguration
VCS
Conguration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Restoring Default Conguration
DefaultValuesSet Level 3
It is possible to restore the VCS to its default conguration. This
is done via the CLI using xCommand DefaultValuesSet. This
command is not available via the web UI.
The DefaultValuesSet command allows you to specify the
level of conguration to restore, from 1 to 3 as follows:
Level 1
•
resets most conguration items to their default value,
with the exception of the items shown in the table opposite.
The xConguration reference table shows a full list of all
conguration items and where applicable their default values.
Level 2
•
is not currently used, so setting this level has the
same effect as setting Level 1.
Level 3
•
resets all conguration items to their default value,
including those shown in the table opposite.
Conguration item Default value after xCommand DefaultValuesSet Level: 3
SystemUnit Name <blank eld>
SystemUnit Password TANDBERG
Option [1..64] Key <all option keys are deleted>
IPProtocol IPv4
IP Gateway 127.0.0.1
IP V6 Gateway <blank>
IP DNS Server [1..5] Address <blank>
IP DNS Domain Name <blank>
Ethernet [1..2] Speed Auto
Ethernet [1..2] IP V4 Address 192.168.0.100
Ethernet [1..2] IP V4 SubnetMask 255.255.255.0
Ethernet [1..2] IP V6 Address <blank>
NTP Address <blank>
SNMP Mode On
SNMP CommunityName public
SNMP SystemContact <blank>
SNMP SystemLocation <blank>
Administration TimeOut 0
ExternalManager Address <blank>
ExternalManager Path tms/public/external/management/SystemManagementService.asmx
Policy AdministratorPolicy Mode Off
Policy UserPolicy Mode Local
Policy UserPolicy Server Protocol HTTP
Policy UserPolicy Server Address <blank>
Policy UserPolicy Server Path <blank>
Policy UserPolicy Server UserName <blank>
Policy UserPolicy Server Password <blank>
Overview
!
xCommand DefaultValuesSet Level: 3 must be
used with caution, as it resets the system’s IPv4 and
IPv6 addresses, meaning you will no longer be able to
access the system over IP. It also deletes all option keys
including pre-installed options such as Expressway and the
number of registrations and calls.
 previous next