TANDBERG Security Camera Security Camera User Manual


  Open as PDF
of 247
 
208
D14049.03
MAY 2008
Grey Headline (continued)
Zones LocalZone Traversal H323 H46019 Demultiplexing Mode: <On/Off>
Determines whether the VCS will operate in Demultiplexing mode for calls from traversal-enabled endpoints registered directly with it.
On: allows use of the same two ports for all calls.
Off: Each call will use a separate pair of ports for media.
Default: Off
Example: xConguration Zones LocalZone Traversal H323 H46019 Demultiplexing Mode: Off
Zones LocalZone Traversal H323 Preference: <Assent/H46018>
If an endpoint that is registered directly with the VCS supports both Assent and H460.18 protocols, this setting determines which the VCS uses.
Default: Assent
Example: xConguration Zones LocalZone Traversal H323 Preference: Assent
Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a TCP probe to the VCS once a call is established, in order to keep the
rewall’s NAT bindings open.
Default: 20
Example: xConguration Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: 20
Zones LocalZone Traversal H323 TCPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a TCP probe to the VCS.
Default: 5
Example: xConguration Zones LocalZone Traversal H323 TCPProbe RetryCount: 5
Zones LocalZone Traversal H323 TCPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a TCP probe to the VCS.
Default: 2
Example: xConguration Zones LocalZone Traversal H323 TCPProbe RetryInterval: 2
Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a UDP probe to the VCS once a call is established, in order to keep the
rewall’s NAT bindings open.
Default: 20
Example: xConguration Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: 20
Zones LocalZone Traversal H323 UDPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a UDP probe to the VCS.
Default: 5
Example: xConguration Zones LocalZone Traversal H323 UDPProbe RetryCount: 5
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Conguration
VCS
Conguration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xConguration
 previous next