TANDBERG Security Camera Security Camera User Manual


  Open as PDF
of 247
 
86
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Conguration
VCS
Conguration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Zones
Conguring Traversal Client Zones
H.323 protocol
Determines which of the two rewall traversal
protocols (Assent or H.460.18) to use for calls
to the traversal server. (See Firewall Traversal
Protocols for more information.)
H.323 port
Species the port on the traversal server to be
used for H.323 calls to and from the local VCS.
SIP transport
Determines which transport type will be used
for SIP calls to and from the traversal server.
SIP port
Species the port on the traversal server to be
used for SIP calls to and from the VCS.
Retry interval
Species the interval in seconds with which a
failed attempt to establish a connection to the
traversal server should be retried.
Primary address
Species the IP address or FQDN of the
traversal server.
Alternate 1 to Alternate 5 address
Species the IP addresses or FQDNs of any
alternates congured on the traversal server.
H.323 mode
Determines whether H.323 calls will be allowed
to and from the traversal server.
SIP mode
Determines whether SIP calls will be allowed to
and from this zone.
For rewall traversal to work via H.323,
the traversal server must have a
traversal server zone congured on it to
represent this VCS, using this same port
number.
For rewall traversal to work via SIP, the
traversal server must have a traversal
server zone congured on it to
represent this VCS, using this same transport
type and port number.
For full details on how traversal client
zones and traversal server zones work
together to achieve rewall traversal,
see Firewall Traversal.
Authentication username
Traversal clients must always authenticate
with traversal servers by providing their
authentication username and password.
The client’s authentication username is
shown here for reference, to make it easier
to congure the corresponding zone on the
traversal server.
The authentication username is a system-wide
setting that is set via VCS Conguration >
Authentication > Conguration.
 previous next