TANDBERG Security Camera Security Camera User Manual


  Open as PDF
of 247
 
223
D14049.03
MAY 2008
Grey Headline (continued)
RouteAdd
Adds and congures a new route.
Address(r): <S: 1, 39>
Species an IP Address used in conjunction with the Prex Length to determine the network to which this route applies.
PrexLength(r): <1..128>
Species the number of bits of the IP Address which must match when determining the network to which this route applies.
Gateway(r): <S: 1, 39>
Species the IP Address of the Gateway for this route.
Interface: <Auto/LAN1/LAN2>
Species the LAN interface to use for this route. Auto: The VCS will select the most appropriate interface to use. Default: Auto
Example: xCommand RouteAdd Address: "10.13.8.0" PrexLength: 32 Gateway: "192.44.0.1"
SubZoneAdd
Adds and congures a new subzone.
SubZoneName(r): <S: 1, 50>
Assigns a name to this subzone.
Address: <S: 0, 39>
Species an IP Address used (in conjunction with the IP Prex Length) to identify a subnet to be assigned to this subzone.
PrexLength: <0..128>
Species the number of bits of the Subnet IP Address which must match for an IP Address to belong in this subzone.
TotalMode: <Unlimited/Limited/NoBandwidth>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any one time.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
PerCallInterMode: <Unlimited/Limited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
PerCallInter: <1..100000000>
Species the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set to Limited).
PerCallIntraMode: <Unlimited/Limited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
PerCallIntra: <1..100000000>
Species the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if Mode is set to Limited).
Example: xCommand SubZoneAdd SubZoneName: "BranchOfce" Address: "10.13.0.0" PrexLength: 28 TotalMode: Limited Total: 1024 PerCallInterMode:
Limited PerCallInter: 512 PerCallIntraMode: Limited PerCallIntra: 512
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Conguration
VCS
Conguration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xCommand
 previous next