Filter
Top Products
64 en | Using the IP AutoDome VG4 Modular Camera System
F.01U.133.268 | 6.0 | 2010.03 User’s Manual Bosch Security Systems, Inc.
Aux Control Tab
The Aux Control tab is used to enter pre-programmed keyboard control commands. See
Section 6 Keyboard Commands by Number, page 43, for a list of all commands. To access the
Aux Control tab, navigate to the Livepage and click the Aux Control tab (see Figure 8.3 below).
Figure 8.3 Aux Control Tab
To Enter a Keyboard Control Command:
1. Place the cursor in the Command Number field.
2. Click the desired command number via the on-screen keypad.
3. Click either the Aux On or the Aux Off button to initiate or stop the command. See
Section 6 Keyboard Commands by Number, page 43, for a list of commands.
4. If the command initiates a menu, use the Up/Down arrows on the View Control to
navigate the menu. Click the Focus or Iris button to select a menu item.
To Set a Preset Shot:
Preset shots (or scenes) are camera positions that are saved in memory for future use.
1. Move your cursor over the live image and wait for the area to display a directional arrow.
2. Click and hold a mouse button to pan to the desired position you want to save.
3. Click any number combination from 1-99 (1-64 for a 200 Series AutoDome, 90-99 for 500i
Series AutoDome are used for motion detection) from the on-screen keypad to identify
the scene number.
4. Click the Set Shot button. The image area displays a message that indicates which shot
number was saved.
NOTICE!
The Aux Control tab can also be used to display the OSD menus. Once the OSD menus are
displayed, the virtual joystick in the View Control tab can be used to navigate the menus, and
the Focus and Iris buttons can be used to make menu selections.
Number Description
1 Command number field
2 Keypad (numbers 0-9)
3 Show a preset shot
4 Set a preset shot
5 Initiates a command
6 Deletes a number in the Command Number field
7 Used to select a menu item
8 Stops a command