Filter
Top Products
VG4 Modular Camera System Configuring the IP AutoDome | en 81
Bosch Security Systems, Inc. User’s Manual F.01U.133.268 | 6.0 | 2010.03
Picture quality
This setting allows you to define the picture quality. Low quality requires a lower bandwidth
in the network.
10.18 Advanced Mode: Audio
You can set the gain of the audio signals to suit your specific requirements. The current video
image is shown in the small window next to the slide controls to help you check the audio
source and improve assignments. Your changes are effective immediately.
If you connect via Web browser, you must activate the audio transmission on the LIVEPAGE
Functions page (see Section 10.13 Advanced Mode: LIVEPAGE Functions, page 76). For other
connections, the transmission depends on the audio settings of the respective system.
Audio
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data are encoded according to G.711 and require an additional
bandwidth of approx. 80 kbps for each connection. If you do not want any audio data to be
transmitted, select Off.
Line In 1
You can set the line input gain. Make sure that the display does not go beyond the green zone
during modulation.
10.19 Advanced Mode: Camera Options
10.20 Camera Settings Group 1
White Balance
Adjusts the color settings to maintain the quality of the white areas of the image.
– ATW: allows the camera to continuously adjust color reproduction.
– Indoor: white balance tracking for indoor use.
– Outdoor: white balance tracking for outdoor use.
– AWB Hold: places the ATW on hold and saves the color settings.
– Extended ATW (default): allows the camera to constantly adjust for optimal color
reproduction.
Gain Control
Adjusts the automatic gain control (AGC). Automatically sets the gain to the lowest possible
value needed to maintain a good picture.
– AGC (default): electronically brightens dark scenes, which may cause graininess in low
light scenes.
– Fixed: no enhancement.
Max. Gain Level
Controls the maximum value the gain can have during AGC operation. To set the maximum
gain level, type a value between 1 and 6 inclusive. The default setting is 4.
Sharpness
Adjusts the sharpness of the picture. To set the sharpness, type a value between 1 and 16
inclusive. The default setting is 12.