Support User Manuals

Enterasys Networks X009-U Camera Accessories User Manual

Open as PDF

of 86

Matrix X4-C Chassis Installation Guide 3-1

3

Matrix X4-C Chassis Setup

Thischapterdescribesthefollowing:

Required Tools

Installationequipmentneededincludes:

•Boxcutter

• Phillipsscrewdriver

•Flatbladescrewdriver

Aboxcutterisrequiredtocuttheshippingstraps.APhillipsscrewdriverisneededtoinstallthe

unitinastandard19‐inch(48.26‐centimeter)equipmentrackandtoinstalltheoptionalCable

ManagementKit(referto“OptionalCableManagement

Kit”onpage 3‐35).Aflatblade

screwdriverisusedtotightenandloosencaptivescrews.RefertoChapter 2,Siteand

ConfigurationGuidelines,forguidelinesthatmustbefollowedtoinstalltheMatrixX4‐Cchassis.

For information about: Refer to page ...

Required Tools 3-1

Unpacking the Matrix X4-C Chassis 3-2

Setting Up the Matrix X4-C Chassis 3-5

Installing and Removing a Power Supply 3-11

Installing and Removing a Fan Tray 3-16

Installing and Removing Modules 3-18

Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit 3-24

Optional Cable Management Kit 3-35

Powering Up the Matrix X4-C Chassis 3-37

LEDs and Reset Button 3-37

First-Time Quick Configuration 3-42

Electrical Hazard: Only qualified personnel should install or service this unit.

Riesgo Eléctrico: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes

Personal vorgenommen werden.

previous next