Support User Manuals

Enterasys Networks X009-U Camera Accessories User Manual

Open as PDF

of 86

Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit

Matrix X4-C Chassis Installation Guide 3-25

3. Holdthetransceiversothattheconnectorwillseatproperly.

4. CarefullyalignthetransceiverwiththeIOMportslot,asshowninFigure 3‐23.

5. PushthetransceiverintotheIOMportuntilitseatswiththeconnectoratthebackoftheslot.

Figure 3-23 Installing XFP/SFP Optical Transceiver

Removing an XFP/SFP Module

ToremoveatransceiverfromanIOM,referback toFigure 3‐23andproceedasfollows:

1. AttachtheantistaticwriststrapbeforeremovingtheXFP/SFPmodule.

2. RemoveanynetworkcableattachedtotheconnectorontheXFP/SFPmodule.Toremovea

connectorfromthetransceiverinterfaceport,graspthehandleandcarefully

pullthe

connectoroutoftheport.Itmayneedtobeloosenedbygentlymovingitfromsidetosideto

releasethelatchingkeys.

3. BeforestoringorshippingtheXFP/SFPmodule,placeitintoastatic‐freecontainer.

Connecting Fiber-Optic Cables

Thissectiondescribesconnecting10‐or1‐GigabitEthernetfiber‐opticsegmentsfromthenetwork

orotherdevicestoXFPorSFPportconnectors(LCorMT‐RJ)onMatrixX4‐CIOMs.

Eachfiber‐opticlinkconsistsoftwofiber‐opticstrandswithinthecable:Transmit(TX)andReceive

(RX).

Thetransmitstrandfromamoduleportconnectstothereceiveportofafiber‐optic

10‐/1‐GigabitEthernetdeviceattheotherendofthesegment.Thereceivestrandoftheapplicable

LCorMT‐RJportonthemoduleconnectstothetransmitportofthefiber‐optic

10‐/1‐Gigabit

Ethernetdevice(showninFigure 3‐24).

1 XFP transceiver 2 Port slot 3 Release handle 4 SFP transceiver

TX RX

2

1

3

TX RX

2

4

3

Caution: Carefully follow the instructions in this manual to avoid damaging the XFP/SPF and IOM

module.

The XFP/SPF and IOM module are sensitive to static discharges. Use an antistatic wrist strap and

observe all static precautions during this procedure. Failure to do so could result in damage to the

XFP/SPF and IOM module. Always leave the XFP/SPF and IOM module in the antistatic bag or an

equivalent antistatic container when not installed.

Precaución: Siga las instrucciones del manual para no dañar el XFP/SPF o la módulo IOM,

puesto que son muy sensible a las descargas de electricidad estática. Utilice la pulsera

antiestática y tome todas las precauciones necesarias durante este procedimiento. Si no lo hace,

podría dañar el XFP/SPF y la módulo IOM. Mientras no esté instalado, mantenga el XFP/SPF y la

módulo IOM en su bolsa antiestática o en cualquier otro recipiente antiestático.

previous next