Support User Manuals

Enterasys Networks X009-U Camera Accessories User Manual

Open as PDF

of 86

LEDs and Reset Button

3-40 Matrix X4-C Chassis Setup

Thefollowingadditionalconditionsapply:

•Afterpowerup,thefantrayLEDremainsreduntildiagnosticsbegin,thenwillblinkgreen.

Whenblinkingamber,thefancontrollerwillrunadefaultconfiguration.

•Anoverheatingwarningindicatesfansarerunningathighspeed.Fansoperateatnormal

speedifnowarningisreceived.

Module LEDs and Reset Button

Control and Fabric Module LEDs

TwoLEDsareprovidedforCMsandFMs,STATUSandACTIVE/STANDBY,asshownin

Figure 3‐38.Additionally,Speed(10/100/1000Mbps)andStatusLEDsontheCMEthernetRJ45

portindicatea10,100,or1000Mbpslink.LEDdefinitionsareprovidedinTable 3‐3.

TheCMalsoprovidesaReset

buttonwhichwarm‐rebootsthemodule,suspendingserviceforthe

durationofthereboot.IftwoCMsareinstalledhowever,serviceisnotinterrupted.

Figure 3-38 Fabric and Control Module LEDs and Reset Button

Caution: If the LED remains red, replace the fan tray immediately. Otherwise, the system may

overheat and damage chassis components.

Precaución: Si observa que la lucecita roja no se apaga, cambie inmediatamente el sistema de

ventilación. Si no lo hace, el sistema se sobrecalentará y los componentes del chasis se dañarán.

1 STATUS LEDs 3 RESET button 5 Link LED

2 ACTIVE/STANDBY LEDs 4 10/100/1000 LED

STATUS

ACTIVE/

STANDBY

RESET

ETHERNET

STATUS

ACTIVE/

STANDBY

1

2

1

2

3

4

5

Fabric Module Control Module

previous next