Support User Manuals

Enterasys Networks X009-U Camera Accessories User Manual

Open as PDF

of 86

Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit

3-28 Matrix X4-C Chassis Setup

Figure 3-25 Connecting an IBM PC or Compatible

Connecting the CM COM Port to a VT Series Terminal

ToconnectaVTSeriesterminaltotheCMCOMport(Figure 3‐26),useaUTPcablewithRJ45

connectorsandauser‐suppliedRJ45‐to‐DB25femaleadapter.Proceedasfollows:

1. ConnecttheRJ45connectoratoneendofthecabletotheCOMportontheCM.

2. Plugthe

RJ45connectorattheotherendofthecableintoauser‐suppliedRJ45‐to‐DB25female

adapter.

3. ConnecttheRJ45‐to‐DB25adaptertotheportlabeledCOMontheVTterminal.

4. TurnontheterminalandaccesstheSetupDirectory.Setthefollowingparameters:

5. ConnecttheX4‐C’spowercords.

Referto“PoweringUptheMatrixX4‐CChassis”on

page 3‐37.

1 UTP cable with RJ45 connectors 3 RJ45-to-DB9 PC adapter

2 RJ45 COM port 4 IBM PC or compatible device

STATUS

ACTIVE/

STANDBY

RESET

USB

ETHERNET

COM

2

34 1

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=19,200

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

previous next