Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Reference — Kodak Driver Software 8-55
“A parity hardware error
has been found in the
cabling or in the camera
during image transfer.
Verify that SCSI cables are
connected properly.”
A hardware error has
been detected in the
cabling or in the camera.
Verify that all SCSI connections are
correct (if necessary turn off all
equipment to alter the
connections). Try other cables if
available. If the problem persists,
contact Kodak.
“A problem occurred
when the driver tried to
communicate with the
camera (the SCSI manager
is busy and cannot handle
the current request at this
time). Please try again.”
A problem occurred
when the software driver
tried to communicate
with the camera.
Try again; if the problem persists,
contact Kodak.
“A problem occurred
with the TWAIN driver,
and the matrix file
‘filename’
is not
compatible with the
current TWAIN driver.
Reinstall the driver and try
again.”
A problem occurred with
the software driver,
perhaps during
installation.
Reinstall the TWAIN driver as
described in Chapter 4, and try
again.
If the problem persists, obtain a
new driver (refer to the appendix
“Updating Your KODAK Software
Driver”), install it, and try again.
“A problem with the
hardware has been
detected. (Timeout during
command phase.) Verify
that SCSI cables are
connected properly, and
that the camera has a
unique SCSI ID, and then
try again.”
A problem with the
camera hardware has
been detected.
Verify that all SCSI connections are
correct (if necessary turn off all
equipment to alter the
connections), make sure the
camera has a unique SCSI ID, and
try again.
Message Possible Cause Suggested Solution