Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8-56 Reference — Kodak Driver Software
“A problem with the
hardware has been
detected. (Timeout during
data phase.) Verify that
SCSI cables are connected
properly, and that the
camera has a unique SCSI
ID, and then try again.”
A problem with the
camera hardware has
been detected.
Verify that all SCSI connections are
correct (if necessary turn off all
equipment to alter the
connections), make sure the
camera has a unique SCSI ID, and
try again.
“A problem with the
hardware has been
detected. (Timeout during
message phase.) Verify
that SCSI cables are
connected properly, and
that the camera has a
unique SCSI ID, and then
try again.”
A problem with the
camera hardware has
been detected.
Verify that all SCSI connections are
correct (if necessary turn off all
equipment to alter the
connections), make sure the
camera has a unique SCSI ID, and
try again.
“A problem with the
hardware has been
detected. (Timeout during
selection phase.) Verify
that SCSI cables are
connected properly, and
that the camera has a
unique SCSI ID, and then
try again.”
A problem with the
camera hardware has
been detected.
Verify that all SCSI connections are
correct (if necessary turn off all
equipment to alter the
connections), make sure the
camera has a unique SCSI ID, and
try again.
“A problem with the
hardware has been
detected. (Timeout during
status phase.) Verify that
SCSI cables are connected
properly, and that the
camera has a unique SCSI
ID, and then try again.”
A problem with the
camera hardware has
been detected.
Verify that all SCSI connections are
correct (if necessary turn off all
equipment to alter the
connections), make sure the
camera has a unique SCSI ID, and
try again.
Message Possible Cause Suggested Solution