Filter
Top Products
83
Remote Viewing Interface
• Buzzer: Select OFF to disable the buzzer when the system detects a motion event or select
the duration of the buzzer after the system detects a motion event.
Click and drag to configure
motion detection areas
Red: Motion detection enabled
Clear: Motion detection disabled
• Full Screen: Select the checkbox so that the channel goes into full screen mode when motion
is detected.
• Enable Record: Sel
ect to enable system recording when motion is detected.
• Post Recording: Sel
ect the post-recording time after a motion event occurs.
• Record Channel: Sel
ect the channels that should record during a motion event.
• Show Message: Sel
ect the checkbox to enable the system to display a warning message
during a motion event.
• Send Email: Sel
ect the checkbox for the system to send a email notification during a motion
event.
3 Drag your mouse cursor in the window to select the desired area to monitor the channel for
motion.
4 Click Sav
e to apply your settings.
Configuring your System to "Beep" During Motion
You can set your system to "beep" during motion. This is useful to notify you if someone
enters or exits an area.
To configure the system to "beep" during
motion:
1 Click the Remote Setting t
ab, and click Alarm>Motion.
2 In the Channel drop-down menu, select the channel you wish to configure.
3 Select the Enable chec
kbox.
4 Beside the Buz
zer drop-down menu, select the "beep" duration or select OFF to disable the
"beep."
5 In the video window, select the area you wish to monitor for motion.
6 Click Sav
e to apply your settings.
Result: The system
beeps when it detects motion, and a green "M" icon appears. The green
"M" icon indicates that the system is only detecting motion, but not recording. To have the
system record motion events, enable motion recording in the recording calendar (Remote