Filter
Top Products
79
Remote Viewing Interface
Configuring Basic Network Settings
The basic network menu allows you to configure the network protocol type (DHCP or
Static), UPnP and mobile phone login information.
To configure basic network settings:
1 Click the Remote Setting t
ab, and click Network.
2 Configure the following under Basic Configuration:
• Type: Sel
ect between DHCP or Static. If you select Static, you can edit the IP address, Subnet
Mask, Gateway, and DNS settings.
• Auto Port Forwarding: Select Ena
ble or Disable to enable or disable the Auto Port Forwarding
feature.
3 Click Sav
e to apply your settings.
Configuring the System Substream
You can adjust the data streaming rate (also called the SubStream) when you connect to
the system remotely. If you want to conserve bandwidth, select a lower frame rate and
bitrate.
NOTE: Setting your sys
tem to stream with a lower frame and bitrate may cause the video to
appear choppy or slow.
To configure the system’s substream:
1 Click the Remote Setting t
ab, and click Network>SubStream.