Filter
Top Products
49
Using the Main Menu
• Sensitivity: Select motion sensitivity. The
greater the number, the greater the
sensitivity.
• Show Message: Select the checkbox if you
want
the system to display a system
message when an alarm triggers.
• Buzzer: Sel
ect the duration the system
will "beep" when motion is detected. Or
select OFF to disable the "beep" during
motion events.
• Send Email: Sel
ect the checkbox if you
want the system to send email
notifications if an alarm triggers. Email
notifications must be configured.
• Record Channel: Sel
ect the channel you
wish the DVR to record during motion
recording.
• Full Screen: Select the Full Screen chec
k
box so that the system goes into full screen
mode when motion is detected.
• Post Recording:
Enter the post recording
duration (the time the system continues to
record after a motion event occurs).
3 Cl
ick A
pply to save your settings.
Configuring Alarm Settings
(16-Channel ECO Blackbox+ Only)
The Alarm settings menu allows you to
configure how the system behaves
when an external alarm device (not
included) is triggered.
To configure the Alarm tab:
1 From the Alarm menu, click the Alarm
ta
b.
2 Configure the following:
• Alarm In: Sel
ect the channel you wish to
configure.
• Alarm Type: Sel
ect the alarm type of the
device. Choose from N/O (normally open),
N/C (normally closed).
• Alarm Out: Select the checkbo
x to enable
the system’s alarm block to trigger a
connected external alarm.
• Latch Time: Ent
er the duration the alarm
continues to trigger after the event ends.
• Show Message: Select the checkbox if you
want
the system to display a system
message when an alarm triggers.
• Buzzer: Sel
ect the checkbox to enable the
system to "beep" if an alarm triggers.
• Send Email: Select the
checkbox if you
want the system to send email
notifications if an alarm triggers.
• Post Recording: Sel
ect the duration the
system continues to record as an event
after the alarm trigger ends. For example,
if you select 30s (30 seconds), the system
continues to record for 30 seconds after
the alarm trigger ends.
• Full Screen: Sel
ect the Full Screen check
box so that the system goes into full screen
mode when motion or an alarm trigger is
detected.
3 Click Apply t
o save your settings.