Panasonic AG-3DP1G Camcorder User Manual


 
104
Chapter 6 Manipulating Clips with Thumbnails
RUN DOWN CARD:
The maximum number of overwrites on the P2 card
has been exceeded.
DIR ENTRY NG CARD:
The directory structure on the P2 card is not
supported.
For details on P2 card status indications, refer to [2.
L/R P2 card status (remaining free space)].
If the number of recorded clips reaches the limit
(1000) on the P2 card status indicator, “OVER MAX
NUMBER CLIPS” is displayed in the WARNING field.
When “USED” is selected:
2
5
1
3
4
1 Write-protect mark
The
mark appears if the P2 card is write-protected.
2 L/R P2 card status (used memory capacity)
The used memory capacity of the P2 card is indicated
by a bar graph and a percentage figure. The bar
graph indicator moves to the right as the used memory
capacity increases.
The following indications may appear, depending on
the card status:
FORMAT ERROR!:
An unformatted P2 card is inserted.
NOT SUPPORTED!:
An unsupported card is inserted in the camera.
NO CARD!:
P2 cards are not inserted.
Use the cursor button to place the cursor on the P2
card for data you want to access and press the SET
button to display detailed information about the P2
card to check individual information such as the serial
number and the user ID.
3
L/R P2 card used memory capacity/total capacity
Displays the used memory capacity on a P2 card and
the total capacity in minutes. The digits representing
less than minutes are rounded down. The used memory
capacity of a write-protected P2 card is displayed as
100
%.
Note that the indicated capacity will vary according to
the frame rate in native recording with VFR operation.
4 Used 3D/2D LL recording capacity
Displays the used memory capacity for recording,
calculated from the used memory capacity of the P2
cards inserted into card slots L and R.
5
Warning symbol
Inserting the following type of P2 cards will display the
(
) symbol.
RUN DOWN CARD:
The maximum number of overwrites on the P2 card
has been exceeded.
DIR ENTRY NG CARD:
The directory structure on the P2 card is not
supported.
For details on P2 card status indications, refer to [2.
L/R P2 card status (used memory capacity)]
If the number of recorded clips reaches the limit
(1000) on the P2 card status indicator, “OVER MAX
NUMBER CLIPS” is displayed in the WARNING field.
SD memory card Status Display
The status display enables a confirmation of the SD
memory card formatted condition, available memory
capacity etc. From the thumbnail menu, select PROPERTY
DEVICES SD CARD.
If the format is compatible with SD standards, the message
SD ST
ANDARD : SUPPORTED
If the format is not compatible with SD standards, the
message
SD ST
ANDARD : NOT SUPPORTED
is displayed. If this is the case, writing or reading will
not be successful. Format the card with the unit. For
more information on formatting SD memory cards, see
[For
matting SD Memory Cards] (page 100).