Filter
Top Products
77
Chapter 4 Adjustments and Settings for Recording
NOTE
• Pressing the RESET button when a value that can be
adjusted is selected in the setting menu LCD SETTING will
return the setting to its factory default.
• When closing the LCD monitor make sure that it is shut tight.
• In an environment with sudden temperature changes,
condensation may form on the liquid crystal surface of the
monitor. If this happens, wipe off the moisture with a soft, dry
cloth.
• When a cloth is used to wipe dew or dirt off the LCD monitor,
discoloration may appear on the screen. This is not a
malfunction. The discoloration disappears in a few minutes.
• When the camera-recorder is very cold, the video image
in the LCD monitor will appear slightly darker immediately
after the power is turned on. Once the interior of the camera-
recorder warms up, the LCD monitor delivers normal
brightness.
• The image on the LCD monitor may remain if the battery or
the power plug of an external DC power supply is removed
when the camera is on. This is normal and not a malfunction.
This image will disappear if the camera is left idle.
• Image lag may increase at low temperatures, but this is not a
malfunction.
Adjusting Left and Right Viewfinder
Positions
1
Loosen the viewfinder left-right positioning ring.
2
Slide the viewfinder left and right to find a
position that facilitates viewing.
Viewfinder left-right positioning ring
3
Tighten the viewfinder left-right positioning ring.
Diopter Adjustment
1
Set the POWER switch of the camera to ON.
• Look at the image in the viewfinder.
2
Turn the diopter adjusting ring until you get the
sharpest possible image in the viewfinder.
Diopter adjusting ring
Emphasizing Image Outlines
Emphasizing outlines of images in the viewfinder and on
the LCD monitor makes it easier to focus.
This function does not affect video output from the camera
or video recorded by the camera.
1
Adjust EVF PEAK LEVEL and EVF PEAK
FREQ in the DISPLAY SETUP screen.
PUSH MENU TO RETURN
EVF PEAK FREQ
LCD SETTING
LCD BACKLIGHT
ZEBRA1 DETECT
ZEBRA2 DETECT
ZEBRA2
0
LOW
>>>
NORMAL
100%
MARKER ON
85%
SPOT
EVF PEAK LEVEL
DISPLAY SETUP