Panasonic AG-3DP1G Camcorder User Manual


 
40
Chapter 3 Recording and Playback
Special Recording Modes
During P2 card recording, interval recording can be
enabled from the RECORDING SETUP screen.
The interval recording mode is available only with the
following settings:
SYSTEM MODE REC FORMAT Other conditions
1080-59.94i
AVC-I 100/60i
AVC-I 50/60i
720-59.94P
AVC-I 100/60P
AVC-I 50/60P
Turn VFR OFF
1080-50i
AVC-I 100/50i
AVC-I 50/50i
720-50P
AVC-I 100/50P
AVC-I 50/50P
Turn VFR OFF
Interval Recording (INTERVAL REC)
This function is used to record 1 frame at the time interval
set in the INTERVAL TIME item.
1 frame
recording
1
frame
recording
1 frame
recording
(time)
Set
INTERVAL
TIME setting
Set INTERVAL
TIME setting
1
Check that the SYSTEM SETUP screen is set
up as shown in the left table.
For details on menu operation, refer to [Using the
Menus] (page 106).
2
Select INTERVAL in the menu option REC
FUNCTION in the RECORDING SETUP
screen.
3
Set the time in the menu option INTERVAL
TIME in the RECORDING SETUP screen.
4
Press the REC button.
The camera will repeat 1-frame recording for the
time interval set in the INTERVAL TIME option.
Press the STOP button to stop recording.
To cancel this function, turn the camera off or
select NORMAL in the REC FUNCTION option.
The following indications appear to the left of the
operation status display.
• During recording: “I-REC” stays lit.
During a pause: “I-PAUSE” stays lit.
When a setting of less than 2 seconds is made
in step 3, “I-REC” blinks according to time
setting during recording.
• When stopped: “I-” in “I-PAUSE” blinks.
NOTE
• Sound is not recorded.
• Data recorded (until the STOP button is pressed) in
this mode is recorded as a single file.