Panasonic AG-3DP1G Camcorder User Manual


 
41
Chapter 3 Recording and Playback
REC CHECK Function
Pressing the USER button (USER MAIN, USER1 or USER2)
or the RET/REC CHECK button to which REC CHECK has
been assigned will automatically locate and play back the
last two seconds of the most recent clip.
Use this function to check that recording is performed
normally. The camera returns to recording standby mode
after playback.
You can use menu options USER MAIN, USER1, USER2,
and RET in the SW MODE screen to assign the REC
CHECK function to the desired button.
Shot Marker (SHOT MARK)
Recording Function
This function can be used to distinguish a clip from other
clips by adding a thumbnail to each clip.
This also makes possible to display or play back the
marked clips only.
To add shot marks
1
In the SW MODE screen, assign SHOT MARK
to a user button (USER MAIN, USER1 or
USER2).
For details on menu operation, refer to [Using the
Menus] (page 106).
2
Press the USER button to which SHOT MARK
has been assigned during recording or when
recording is paused.
SHOT MARK ON is displayed as a shot mark is
inserted in the currently recorded clip.
Pressing this key a second time displays SHOT
MARK OFF and the shot mark is deleted.
NOTE
• A shot mark added during a pause after recording is added
to the most recently recorded clip.
• Shot marks can be added also in the thumbnail display.
• The shot mark function is not available during, interval
recording. When this function is not available, pressing this
button displays SHOT MARK INVALID.
• Shot marks can be set or cancelled in playback pause mode
but not during playback.
• Shot marks are added on the “L” P2 card only.