Filter
Top Products
110
Chapter 7 Menu Operations
Setup Menu List
SCENE FILE Screen
Item Setting Notes
FILE SELECT Select the file you wish to use for shooting among six
scene files.Select number 1 to 6 that corresponds to
FILE1 to FILE6, respectively.
•
The factory default settings are the
same for 1 to 6.
LOAD/SAVE/INIT Loads, saves, and initializes the settings of the scene
file selected in FILE SELECT.
LOAD: Loads data stored in camera memory.
SAVE: Saves current values in camera memory.
INITIAL: Returns settings to their factory defaults.
•
This setting does not affect scene files
that are not the currently selected one.
VFR
Enables or disables variable frame rate (VFR) mode at
720P.
ON: VFR operation
OFF: VFR off
•
Available only in 720P system mode.
(This message does not appear in
modes other than 720P.)
FRAME RATE
Adjusts the frame rate and exposure time at 720P
when VFR is on.
•
When 59.94 Hz is selected
12, 15, 18, 20, 21, 22, 24, 25, 26, 27, 28, 30, 32, 34,
36, 40, 44, 48, 54, 60 FRAME
• When 50 Hz is selected
12, 15, 18, 20, 21, 22, 23, 24, 25, 26, 27, 28, 30, 32,
34, 37, 42, 45, 48, 50 FRAME
• Available only in 720P system mode
and when VFR is set to ON.
(This message does not appear in
modes other than 720P.)
•
A change to 24 fps may cause the
screen to flicker momentarily.
(SYNCHRO SCAN)
Displays synchro scan shutter speeds to enable the
operator to synchronize the camera to computer
monitors.
•
This function only displays the shutter speeds. Use
the SYNCHRO SCAN switch to set a shutter speed.
•
Set values (displayed values) are assigned to the
current scene file and manipulated using the LOAD,
SAVE and INIT functions.
For details, refer to [Placing the Camera-recorder in
SYNCHRO SCAN Mode] (page
49).
• When 59.94 Hz is selected
1/60.0
• When 50 Hz is selected
1/50.0
•
Displayed in blue when not set to
synchro scan mode and when the
SYNCHRO SCAN switch settings are
not available.
DETAIL LEVEL
Adjusts the level of image outline correction (in
horizontal and vertical directions).
–7 ... 0 ... +7
V DETAIL LEVEL
Adjusts the level of correction in vertical direction.
–7 ... 0 ... +7
DETAIL CORING
Adjusts the level of noise reduction of the detail signal.
–7 ... +5 ... +7
•
Adjust towards – for a clearer image. Noise
increases slightly.
•
Adjust towards + for less noise.
CHROMA LEVEL
Adjusts the chroma level.
–7 ... 0 ... +7
CHROMA PHASE
Makes fine adjustments to the chroma phase.
–7 ... 0 ... +7
COLOR TEMP Ach
Makes fine adjustments to the color temperature (after
Ach white balance adjustment).
–7 ... 0 ... +7
COLOR TEMP Bch
Makes fine adjustments to the color temperature (after
Bch white balance adjustment).
–7 ... 0 ... +7
____ indicates the factory setting