Filter
Top Products
124
Chapter 9 Maintenance and Inspections
Inspecting the Memory Recording
Functions
Make sure you successively carry out the inspections from
[Inspecting the P2 Card Recording] to [Inspecting the
Earphone and Speaker].
Inspecting the P2 Card Recording
1
Check on the LCD monitor or in the viewfinder
that the remaining P2 card recording capacity
for both P2 cards is sufficient.
For details, refer to [Screen Displays] (page 68).
2
Press the camera’s REC button to check the
following items:
• The P2 card access LEDs blink in orange.
• The REC indication on the screen lights.
•
System warnings do not appear on the screen.
3
Press the camera’s REC button again.
• Check that the P2 card access LEDs light in
orange, and that the REC indication on the screen
is cleared.
4
Using the REC button on the handle, repeat
Steps 2 to 3 to check the same operation.
5
Using the REC button on the lens unit, repeat
Steps 2 to 3 to check the same operation.
6
Press the THUMBNAIL button to switch
the thumbnail screen to play back currently
recorded clip from thumbnail.
• Check that playback is operating normally.
Inspecting the Audio Level Automatic
Adjustment
1
Set the AUDIO SELECT CH1 and CH2
switches to AUTO.
2
Set the AUDIO IN switch to FRONT.
3
Aim the microphone connected to the MIC jack
at an appropriate sound source. Then, check
that the level displays for both CH1 and CH2
change according to the sound level.
Inspecting the Audio Level Manual
Adjustment
1
Set the AUDIO IN switch to FRONT.
2
Set the AUDIO SELECT CH1 and CH2
switches to MAN.
3
Turn the AUDIO LEVEL CH1 and CH2 controls.
• Check that the level display increases when the
controls are turned to the right.
Inspecting the Earphone and Speaker
1
Turn the MONITOR control to check that the
speaker volume changes.
2
Connect an earphone to the PHONES jack.
• Check that the speaker is turned off and the
microphone sound can be heard from the
earphone.
3
Turn the MONITOR control to check that the
earphone volume changes.