Filter
Top Products
24
Chapter 2 Parts and their Functions
Menu/Thumbnail Operation Section
3
2 1
7
6 5 4
1 MENU button
Hold down the button to open a setting menu screen. A
second press of the button returns the previous image.
This function is not available in the thumbnail display
and during recording.
2
JOG dial button
Use this button to go between setting menus and to
select and set items in open setting menus.
In a setting menu, turning the JOG dial button
downwards moves the menu cursor downwards and
turning it upwards moves the menu cursor upwards.
Press the JOG dial button to confirm made settings.
In VFR (Variable Frame Rate) mode, press this button
and use the SYNCHRO SCAN switch to change frame
rates.
3
THUMBNAIL button
Press this button to open the thumbnail screen. Note
that this switchover cannot be performed during
recording or playback.
This button is also used for iris adjustment in 3D FINE
adjustment mode.
4
MENU (thumbnail menu) button
In thumbnail display mode, use this button to access
thumbnail menu functions to delete clips, for example.
5
Cursor and SET buttons
Use these buttons to manipulate setting menus, the
menu bar and thumbnails.
The four triangular buttons are cursor buttons and the
square center button is the SET button.
These buttons are also used for vertical position
adjustment (VERTICAL), focus adjustment (FOCUS)
and resetting in 3D FINE adjustment mode.
6 EXIT/CANCEL button
Press this button to exit an open thumbnail menu or
property window to return to the previous image.
Pressing this button while holding down the SHIFT
button turns it into a cancel function allowing you to
cancel clip selections at one time.
This button is also used for iris adjustment in 3D FINE
adjustment mode.
7
SHIFT button
Use this button together with other buttons.
•
Hold down the SHIFT button and press the cursor
button ([ ]) in a thumbnail screen to move the
pointer to the thumbnail at the beginning or end of a
clip.
•
Hold down the SHIFT button and press the SET button
to select all clips from a previously selected clip to the
clip at the cursor location.
• SHIFT button + EXIT/CANCEL button
This button combination operates like the cancel
function.
For details, refer to [6. EXIT/CANCEL button].
Operations while the SHIFT button is pressed are
shown blow each button.
This button is also used for switchover to 3D FINE
mode.
NOTE
For details on the use of the buttons, refer to the following
pages:
• For menu operation, refer to [Using the Menus] (page
106).
• For thumbnail operation, refer to [Selecting Thumbnails]
(page 93).
• For 3D FINE operation, refer to [Adjustment between Two
Lenses (3D FINE Function)] (page 57).