Filter
Top Products
Operating Instructions
142
The MPEG-4 format cannot be
used with the recording frequency
or alarm/sensor recording
settings. Disable the recording
frequency and alarm/sensor
recording settings first, then select
the MPEG-4 format.
• If using the MPEG-4 format, the recording
frequency setting, alarm/sensor recording are
not available.
→ Follow the instruction message.
The selected camera does not
support audio. Set the Recording
Setting to [Image Only].
• The camera is not supporting audio, but the
image setting is set to audio and image.
→ Follow the instruction message.
The selected camera does not
support [1280x1024] resolution.
The resolution is temporarily
changed to [320x240]. Change it
to the proper value.
• When registering a camera that does not
support 1280x1024 resolution.
→ Follow the instruction message.
The selected camera does not
support MPEG-4 format. The
format is changed to JPEG.
→ Follow the instruction message.
The time settings for "Before
detected" and "After detected" are
specified on the timer settings. Set
the recording frequency shorter
than "Before detected" and "After
detected" setting.
→ Follow the instruction message.
The time settings for "Before
detected" and "After detected" are
specified on the motion detection.
Set the recording frequency
shorter than "Before detected" and
"After detected" setting.
→ Follow the instruction message.
The time setting for "Before
detected" and "After detected" are
specified on the alarm/sensor.
Set the recording frequency
shorter than "Before detected" and
"After detected" setting.
→ Follow the instruction message.
Message Cause and Remedy