Filter
Top Products
Operating Instructions
143
Recording Capacity Limit
Enter a number in one-byte
character in "Recording Capacity
Limit".
→ Follow the instruction message.
Enter "Recording Capacity Limit". • The Recording Capacity space was blank.
→ Follow the instruction message.
"Recording Capacity Limit" should
be between 100 and 500000.
• A number not between 100 and 500000 was
entered in the Recording Capacity blank.
→ Follow the instruction message.
Set "Recording Capacity Limit" in
the range of XXX MB to XXX MB
(Drive capacity - Guaranteed
Destination Hard Disk Space).
• Recording Capacity for individual cameras is
larger than (Drive capacity - Guaranteed
Destination Hard Disk Space).
→ Follow the instruction message.
“Limit the destination recording
capacity” is set on the preferences
page. Do you want to disable this
setting and enable the "Limit the
recording capacity" setting for
each camera?
• [Limit the destination recording capacity] and
[Limit the recording capacity] cannot be used
simultaneously.
→ Follow the instruction message.
Motion Detection/Alarm
The MPEG-4 format does not
support motion detection
recording. Do you want to change
the format to JPEG?
• If using the MPEG-4 format, the motion
detection recording is not available.
→ Follow the instruction message.
The MPEG-4 format does not
support alarm/sensor recording.
Do you want to change the format
to JPEG?
• If using the MPEG-4 format, the recording
frequency setting, alarm/sensor recording are
not available.
→ Follow the instruction message.
The recording frequency on the
image setting is specified. Set
"Before detected" and "After
detected" setting longer than the
recording frequency setting.
→ Follow the instruction message.
Message Cause and Remedy