Filter
Top Products
Operating Instructions
25
• If you have set the recorded frequency or the alarm recording, the following
window will be displayed when you click [OK].
Disable the settings and select MPEG-4 again.
• If you have set motion detection recording as the timer recording method, the
following window will be displayed.
Disable the settings and select MPEG-4 again.
• If you select the JPEG format, there is a limit to the number of connections
that can be made to the same camera with this software (including BB-
HNP11).
If you select [Audio and images are sent using one connection] on the basic
settings page
(see page 13)
, do not make more than 4 connections to the
same camera.
If you are making more than 4 connections, select [Images and audio are
connected separately].
• If you select the MPEG-4 format, image display will be smoother even if
bandwidth is lower.
If you select the JPEG format, frame rate will be reduced, but image quality
will be higher.
• If the camera disables setting changes, resolution or image quality settings
may not work properly.
• Due to the network environment, you may not record images at the set
intervals or max. bandwidth.
• If you selected [Display the error message if the program does not work in
the specified frequency], the following window will be displayed when the
program does not work at the specified recording frequency.
In this case, set the recorded frequency to a higher value.