Filter
Top Products
Operating Instructions
35
[About Command Execution]
If you do not select "Perform the following control when issuing a
command" in "Controlling Command Execution".
(After 5 seconds from motion detection, alarm detection)
Execute commands for each detection.
Execute commands
When you select "Perform the following control when issuing a command"
"Execute a command only once at the start of recording"
(After 5 seconds from motion detection, alarm detection)
Execute commands only at the start of decetion recording.
Execute commands
When you select "Perform the following control when issuing a command"
Set an interval during which to not execute commands after executing a
command.
(After 5 seconds from motion detection, alarm detection)
Execute commands
specified time
specified time
specified time
:
Motion detection
:
Recording images
:
Alarm detection
Command will not be executed if motion is detected during the
specified time after detection.