Filter
Top Products
Operating Instructions
32
Note
Configure alarm/sensor detection after an alarm/sensor has been attached to
the camera.
Setting alarm/sensor detection without an alarm/sensor causes a malfunction.
Alarm enable
condition
Specify Alarm enable condition ([Rising : GND to Open (High)]
or [Falling : Open (High) to GND]).
• Specify the alarm enable condition after checking the alarm
specification.
• [Rising : GND to Open (High)] is selected automatically
when [Sensor] is selected.
Before Detected/
After Detected
Specify the time before an alarm/sensor is detected or after an
alarm/sensor is detected.
Executing
Commands for
Detection
You can specify commands that execute for alarm detection.
You can configure commands in [Detection Commands] page
(see page
33).
Setting Description