Filter
Top Products
Operating Instructions
31
Setting the alarm/sensor detection method
You can set an alarm/sensor detection method for cameras that have an alarm/
sensor attached.
Alarm/sensor recording can only be enabled for cameras set to the JPEG format
(see page 24).
If the camera is set to MPEG-4 format, change the setting to JPEG format, then
configure the alarm/sensor.
Alarm/Sensor Page
Setting Description
Set the Alarm1/
Sensor Recording /
Set the Alarm2
Recording
After you select the check box, recording will start when the
camera detects a signal.
• If the camera is set to the MPEG-4 format (see page 24), the
following message will be displayed. Click [OK] to change to
the JPEG format.
• Select [Sensor] for sensor supported cameras.