Filter
Top Products
108
File Operations
Chapter 5 Storage and Retrieval of User Setting Data
<FILE PRESET 1> page
<FILE PRESET 2> page
To reset data of files by type of files
To reset data of the operator file, User-Gamma
file, User-MLUT file, and reference file
Position the pointer to the corresponding line then push on
the MENU SEL/ENTER dial.
The data in the corresponding file in built-in memory will
be reset to the initial settings.
The configuration of the USER menu can be reset in the
same manner.
To reset data of the lens files
• To reset data of all lens files, position the pointer to
LENS FILE (ALL) and push on the MENU SEL/
ENTER dial.
• To reset data of a specific lens file, assign the file number
in the No. column and push on the MENU SEL/ENTER
dial to position the pointer to the CLEAR column. Then
push on the MENU SEL/ENTER dial again.
To reset the data of the OHB file
In a case of the OHB file, resetting can be performed by
item.
Position the pointer to OHB FILE then push on the MENU
SEL/ENTER dial. The <OHB FILE PRESET> page will
be displayed.
Position the pointer to the item you wish to reset then push
on the MENU SEL/ENTER dial.
To reset a specific item in the reference file
to the initial setting
The items in the reference file can be reset individually.
1
On the <FILE PRESET 2> page, set 10 SEC CLEAR
to ON.
2
Shift to the menu page on which the item you wish to
reset is located. Position the pointer to the item you
wish to reset then hold the MENU SEL/ENTER dial
pressed.
Continue to hold the MENU SEL/ENTER dial pressed
after the pointer changes to a question mark (?).
After about 3 seconds, the current setting of the
corresponding item will be reset to the initial setting,
and “CLEARED” will be displayed.
If the dial is continuously held pressed, after about
additional 7 seconds, the setting of the corresponding
item that is stored in the reference file will be reset to
the initial setting, and “REF CLEARED” will be
displayed.
To reset the files and settings collectively
All files except the OHB file can be reset simultaneously.
Position the pointer to FILE PRESET (–OHB) on the
<FILE PRESET 2> page then push on the MENU SEL/
ENTER dial. The message “POWER OFF TO SET” will
be displayed. Set the POWER switch of the camera to OFF.
<FILE PRESET 1> F07 TOP
c
OPERATOR FILE
USER MENU
M.S. FORMAT
<FILE PRESET 2> F08 TOP
c
USER GAMMA FILE
USER MLUT FILE
LENS FILE(ALL)
No.: 1 CLEAR: EXEC
REFERENCE FILE
10 SEC CLEAR: OFF
OHB FILE
FILE PRESET (-OHB)
<OHB FILE PRESET> ESC
c
WHITE SHADING(ALL)
BLACK SHADING
BLACK SET
NO OFFSET
MATRIX