Filter
Top Products
113
Using the ARRI Remote Control
Appendixes
Using the ARRI Remote
Control
You can display or change the following items on/from the
ARRI-made WRC-2 (Wireless Remote Control 2).
Items that can be displayed on the WRC-2
• Model name of this camera (F35)
• System format, input voltage to the camera, tape
remaining of the recorder, shutter speed (sec.), time
code, tape loading status of the recorder
1)
• Flashing reminders for battery remaining and tape
remaining
Items that can be changed from the WRC-2
• Frame rate (FPS)
2)
• Starting and ending values for the shutter angle in a
Ramp operation
• Starting and ending values for the frame rate (FPS) in a
Ramp operation
2)
• Shutter compensation mode (COMP MODE: ANGLE,
GAIN, OFF)
• RUN mode of the recorder (recording start/stop)
1)
1) The menu display on the WRC-2 is shown in red if no tape is loaded, in
pale blue if a tape has been loaded but is not running, or in green when the
loaded tape is running.
2) Displayed as Speed on the WRC-2
Connection and preparations
Two types of connection are permitted: direct wiring to the
EXT I/O connector of the camera and wireless connection
via the UMC-3 (Universal Motor Controller).
• In either case, a special cable is required.
• For the WRC-2, version updating is required.
• For the UMC-3, modification for 12 V power or use of
the UMC-3A is required.
For details on ARRI products, contact ARNOLD &
RICHTER CINE TECHNIK.
Notes