Filter
Top Products
112
Using the MSU-900/950
Appendixes
Settings on the MSU-900/950
Set the unit to Engineer mode and set the communication
parameters, using the Ethernet Configuration menu.
For details on operations, refer to the Operation Manual of
the MSU-900/950.
Notes on LAN connection
• For stable operations of the connected devices, use the
system in a local network, without connecting to the
Internet.
• Do not connect any device to the local network other
than the system units for this camera.
Recommended remote control devices for
which operation tests have been made
Sony made
• MSU-900/950
•RM-B750
Equipment from other vendors
HUB CentreCOM FS909M-PS
Menu Item Setting in Bridge mode Setting in Multi mode
Master unit Subordinate unit(s)
Connection Mode selection Bridge MCS
Target IP SET IP addresses of the connected
cameras
No setting required
Master IP SET No setting required IP address of the master
unit
Master/Client
selection
No setting required Client T
MSU No. No setting required 1 2
Negotiation Negotiation AUTO or OFF TT
Speed No setting required if Negotiation
is AUTO.
For the OFF setting, select 10M or
100M.
TT
Duplex No setting required if Negotiation
is AUTO.
For the OFF setting, select HALF
or FULL.
TT
IP Address
Setting
IP Address IP address specific to the MSU TT
Net Mask Value corresponding to the
network environments in use
TT
Gateway
Address
Value corresponding to the
network environments in use
TT