Filter
Top Products
26
Attaching/Detaching Handles
Chapter 2 Installation and Preparations
2-7 Attaching/Detaching
Handles
2-7-1 L Handle
The L handle is attached to the top of the camera head at
the factory.
Three screw holes (for
3
/
8
” camera screws for a tripod) on
the upper side of the L handle can be used for fixing
various accessories.
Mounting the assistant panel
By attaching the supplied assistant panel hanger, you can
mount the assistant panel on the outside of the handle.
Detaching the L handle
If the L handle is not necessary or to be replaced with the
supplied center handle, remove it by loosening the two
screws, using the 3-mm wrench stored in the wrench box
(page 16).
To attach the handle in the original position, reverse the
procedure for detaching.
2-7-2 Center Handle (Supplied)
The supplied center handle can be attached to the top or
rear of the camera head.
Attach it so that the slanting side faces the back (or
bottom).
The screw holes on the upper side of the handle can be used
for fixing various accessories.
Attaching the handle directly to the camera
head
The handle can be attached/detached in the same manner
as the interface box (see page 19).
Attaching the handle to the interface box
mounted on the camera head
First remove the base plate from the handle by loosening
the four screws, then attach it to the interface box.
2
3
O
F
F
O
N
R
U
N
2
G
E
N
L
O
C
K
I
N
T
E
S
T
O
U
T
Assistant panel
Assistant panel
hanger (supplied)
four +B4×8 screws (supplied)
2
3
O
F
F
O
N
R
U
N
2
G
E
N
L
O
C
K
I
N
T
E
S
T
O
U
T
Hex-head screws
Interface box
Base plate
12