Filter
Top Products
28
Preparing the Power Supply
Chapter 2 Installation and Preparations
2
Connect the DC power cord supplied with the AC-
DN2B to the DC IN connector of the interface box or
the CA-F101.
3
Connect the AC-DN2B to an AC power source.
When the AC-DN2B is used, turning on the camera with
an RM-B750 Remote Control Unit connected may make
the RM-B750 inoperable. To reenable use of the RM-
B750, disconnect and reconnect the remote control cable
maintaining the power-on status.
To use a battery pack
The BP-GL95 Lithium-ion Battery Pack can be used.
By attaching the BKP-L551 Battery Adaptor to the
interface box or the CA-F101, connect the BP-GL95
Lithium-ion Battery Pack to the interface box or the CA-
F101.
• Remove the battery pack if the camera will be out of use
for an extended period.
• Charge the battery, using the specified battery charger,
before use.
For charging, refer to the instructions for the battery
charger.
1
Attach the BKP-L551 Battery Adaptor to the interface
box or the CA-F101.
2
Aligning the groove on the BP-GL95 with the
projection on the BKP-L551, slide the BP-GL95 so
that the connectors engage.
3
Connect the DC cable of the BKP-L551 to the DC IN
connector of the interface box or the CA-F101.
When the battery is connected to the DC IN connector of
the interface box or the CA-F101, power is fed to the
camera head, viewfinders connected to the VF1 and VF2
connectors and a device connected to the LENS connector
of the camera head.
Power is not supplied to the recorder mounted on the
camera head. To supply power to the recorder, connect a
power supply to the DC IN connector on the camera head.
Note
Notes
D
C
IN
1
0
.5
V
-1
7
V
LO
C
K
BKP-L551
Interface box (CA-F101)
Note