Filter
Top Products
13
Power Supply
3. Power Supply
The camera is intended for use with 24 V DC. The
acceptable voltage ranges are from 20 to 32 V DC. If the
voltage trops below 18 V or rises above 34 V, a
protective device prevents the camera from being
turned on.
Changing the Fuses
Main fuse: 10 A Picofuse
Accessory fuse: 2,5 A Picofuse
• Remove the on-board battery or the power supply cable.
• Remove the magazine.
• Unscrew the cover FUSE on the electronic housing
with a coin.
• Take a new fuse from the cover FUSE.
• Exchange the defective fuse using tweezers or a
Hirschmann clamp. The accessory fuse is in the front,
the main fuse at the rear.
• Rescrew the cover FUSE with a coin.
NOTE: In order to avoid future problems you should
obtain replacement fuses as soon as possible. Fuses
from other suppliers should be cut to size and bent as
shown in the drawing on the right.
camera front
accessory fuse
main fuse