Filter
Top Products
Magazines
24
Unloading the Magazine
Preparations
• Remove the loop protector.
• Check the counter on the magazine. It must show 0,
otherwise the film has not been fully exposed.
• Open the feed side in daylight.
• Swing away the guide roller arm until it clicks - do not
pull the guide roller arm upwards.
• Pull off the core of the exposed roll.
• If further shooting is to be carried out, the unexposed
film can now be loaded on the feed side.
Tasks in the Changing Bag
• Place the magazine with the take-up side facing
upwards, the empty film container and the black film
wrapper in the changing bag.
• Close the changing bag and place your hands in the
sleeves.
• Open the magazine cover on the take-up side.
• Swing away the guide roller arm until it clicks. Do not
pull the guide roller arm upwards.
Collapsible core:
• Loosen the clamp on the collapsible core.
• Holding the shaft down with your thumbs, brace your
thumbs on the film spindle and pull off the film carefully.
Core adapter and film core:
• Unlock the film core.
Brace your thumbs on the film spindle and carefully
pull off the film with the core adapter and film core.
• Carefully press the core adapter out of the film core,
ensuring that the inner loops of film are not pressed
out with it, and place the core adapter back onto the
film spindle.
• Place the film in the black wrapper and place this in
the film container.
• Lock the film container and seal it down with the tape.
• Open the changing bag.
Final Tasks
• Clean the pressure gate in the magazine throat with
an optic brush and an optic cloth. If very dirty,
moisten the optic cloth with pure alcohol.
• Clean the magazine (see above).
Never remove film deposit with metal tools;
use only the ARRI plastic film track cleaning rod.
•