Filter
Top Products
Accessories
72
All chosen speeds within the acceptable range of 5 to
75 fps (5 to 99,999 fps on the HS camera) can be
increased or decreased in steps of 1/1000 fps in order
to carry out a fine-tuning of the speed. For fine-tuning on
the camera see chapter 9. To fine-tune on the camera
control unit:
• Switch the sliding switch on the camera to PS/CCU.
• Pre-select the speed.
• In the SPEED menu depress key 9.
• Switch the camera to mode 2.
• Carry out fine-tuning: increase speed with key F1,
decrease speed with key F2.
• Leave fine-tuning with the EXIT key.
The REMOTE Menu
In the REMOTE menu the camera control unit displays
the same information as the camera display. The keys
F1 to F3 take on the meaning of the operating elements
on the camera:
F1 PHASE key
F2 MODE key
F3 SET key (RESET on the CCU)
In the lower line on the display the key functions are
shown. For the ARRIFLEX 16SR 3 only the displays for
keys F1, F2 and F3 are valid.
Operation of the camera in the REMOTE menu is
carried out parallel to operation with the corresponding
keys on the camera. See chapter 9.
The TIMECODE Menu
In the TIMECODE menu the current values and the most
recently set values on the camera control unit for time
code and all user bits are displayed and can be reset.
To change TC-time:
• Depress key 1 - „TIMECODE“ is displayed against a
dark background.
• Depress the ENTER key - ready for input of the new
TC-time.
• Enter all 6 positions of TC-time within the acceptable
range of 00:00:00 to 23:59:59 - the new TC-time is
displayed. If input is finished with the ENTER key, the
unfilled positions will be filled with zeros.
• Depress the SEND key - the new TC-time is transmitted
to the camera.