ARRI 16SR3 Film Camera User Manual


 
7
Installation
2. Installation
Packing and Transport
The camera should be stored in the sturdy ARRI
transport case with the magazine attached, without
the lens, the viewfinder extension, or the on-board
battery. The video camera and the anti flicker
processor should be removed for transport or shipping
purposes. The AC/DC converter can stay on the
camera. There are compartments for two on-board
batteries and the viewfinder extension. An adjustable
compartment enables storage of further equipment
such as the bridge plate or an additional magazine.
A compartment in the case lid is designed to hold
the bridge plate support rods 440mm (19").
Tripod Heads
The ARRIHEAD 2 with its compact construction is
ideally suited to the ARRIFLEX 16SR 3. The hydro-
heads ARRI 150 H, ARRI 150 M and ARRI 100 L
can be used as well.
Bridge Plate BP-6
The bridge plate allows quick mounting and balancing
of the fully-equipped ARRIFLEX 16SR 3 system on the
tripod.
The bridge plate consists of the base plate ,
sliding upper plate and support rods .
The standard length of the support rods is 440 mm
(19"). Support rods of 240 mm (9") length are
available. A quickly atachable wedge plate allows
mounting of the system without the base plate on the
tripod or the ARRIHEAD 2.
For changing from Normal 16 to Super 16 the revers-
ible, center-mounting plate on the upper sliding plate
must be reversed to the appropriate position. See
chapter 8.
For mounting see next page.