Filter
Top Products
Display and Operating Elements
56
TC TC-recording is turned on (see chapter 12).
TC flashes Standby: since the last synchronization
more than 8 hours have passed or the TC-
generator has malfunctioned.
Run: as yet no recording has taken or is
taking place (see chapter 12).
bat Battery voltage < 20 V. The camera
cannot be started.
asy The camera is running asynchronously.
end Indicator of the film end.
Indicators independent of the mode:
Locking the SEL and SET Keys
The keys SEL and SET can be mechanically locked in
order to avoid unintentional changing of the set values.
• Set the sliding switch to LOCK - SEL and SET
can no longer be activated.
The values can still be changed through the CCU-1.
Setting the Speed
At the setting NORM on the sliding switch the standard
speeds 24,00/25,00/29,97 and 30,00 fps are
available. At the setting PS/CCU, any desired speed
within the acceptable range of 5 to 75 fps at 1/1000
fps can be exactly set. On the HS camera (high speed)
speeds from 5 to 99,999 fps at 1/1000 fps and speeds
from 100 to 150 fps at 1/10 fps can be exactly set. Switch-
ing between standard and programmable speed is also
possible while the camera is running.
Camera Running
Camera run is started and stopped with the RUN key.
The RUN function can also be activated by:
- the camera handgrip
- the shoulder set S-3
- remote control units RS-3 and RS-4
- the camera control unit CCU-1
- the external synchronization unit ESU-1
- the lens-control-system LCS
The LED for camera run shows if the camera is running
synchronously (green) or asynchronously (red).