Filter
Top Products
Accessories
70
• Insert the battery pack into the camera control unit
and close the battery compartment.
Pay attention to the correct polarity of the
battery pack!
Plugging in the Camera Control Unit
• Plug the cable KC 24 (2,4m) or KC 30 (20m) into the
socket on the side of the camera control unit,
pressing the slide on the plug in the direction of the
plug.
• Plug the cable to the CCU-socket on the camera.
• Switch on the camera.
• Switch on the camera control unit with the red key
on the side.
Key Functions in all Menus
RUN switches the camera on or off.
SEND sends the chosen values to the camera.
HELP shows the help text for the activated menu.
Cannot be used in the input mode. The help
text can be left by pressing the ENTER key.
EXIT ends input or leaves the activated menu.
LIGHT switches display illumination on or off.
Error Readings
In the case of functional errors on the camera the
display on the camera control unit will show an error
reading in the upper right-hand corner. The error
reading remains visible until the error has been cor-
rected. If the error is caused by the user, an error
reading appears and disappears the next time a key is
depressed. Simultaneously an acoustic signal is audible;
this can however be turned off.
push
button
on/off
bushing