ARRI 16SR3 Film Camera User Manual


 
Camera Body
30
Attaching the Magazine onto the
Camera
Do not use HS magazines on a standard
camera or standard magazines on a HS
camera.
If appropriate press the button on the video
carrying handle and swing the handle to the left side
of the camera.
If appropriate swing back the on-board battery.
Remove the loop protector and the aperture cover plate.
Center the film loop in reference to the pressure plate,
and make sure the film is held in place by the four
guide pins.
Flip the safety latch to the back .
Grasp the upper part of the magazine and hold it on
approx. 30° slant (two o'clock) position.
Push the pilot pin on the magazine forwards
into the camera housing.
Carefully press the back part of the magazine down-
wards until it locks in place.
The red markings on the casing should
no longer be visible!
Flip safety lever to the front.
Check that magazine is locked securely by lifting the
back part of the magazine.
If appropriate swing back the on-board battery and
the video carrying handle.
Set the film sensitivity on the camera´s exposure meter
and reset the film counter.
Check the TC sensitivity setting on the magazine.