IBM 31Y Security Camera User Manual


 
22 Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,
PCNTNW-
NW-072
A resource tag is unavailable.
Explanation: The driver tried to allocate
some resources that were not available.
Action: Add more memory, or free some
memory resources in the server. Then,
restart the server.
PCNTNW-
NW-073
Unable to allocate memory
Explanation: The driver failed to allocate
the memory needed for normal operation.
Action: Add more memory, or free some
memory resources in the server. Then,
restart the server.
PCNTNW-
NW-074
The hardware interrupt cannot be set.
Explanation: An attempt was made to
initialize a given hardware interrupt. The
attempt was not successful.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic
programs” on page 11 to run the
diagnostic programs. If you have an
Ethernet adapter installed, make sure that
the adapter does not share an IRQ with
any other device.
PCNTNW-
NW-075
The Multiple Link Interface Driver
(MLID) cannot be registered with the
Link Support Layer (LSL).
Explanation: An error occurred while the
driver was trying to register with the LSL.
Action: Check the version of the
NetWare or IntraNetWare Operating
System. Make sure that this driver is
correct for the version of NetWare or
IntraNetWare that you are using. Restart
the server.
PCNTNW-
NW-079
The Multiple Link Interface Driver
(MLID) did not initialize MSMTx Free
Count.
Explanation: The MSMTx Free Count is
not initialized correctly.
Action: Restart the server. If the problem
persists, go to “Starting the diagnostic
programs” on page 11 to run the
diagnostic programs.
Table 2. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller