IBM 31Y Security Camera User Manual


 
28 Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,
UNIX messages
This section provides descriptions of the Ethernet error mes-
sages for the SCO UNIX LLI driver, and suggested actions
to resolve each problem.
PermaNet
Server:
Switching back to Primary Adapter.
Explanation: The primary Ethernet
connection is now operating correctly.
Network traffic will automatically transfer
to the primary Ethernet controller.
Action: None needed, message is for
information only.
Table 5. UNIX LLI driver messages for the Ethernet
controller
pnt0-2 PCI search specified, PCI device not found!
Explanation: The driver cannot locate the
Ethernet controller on the PCI bus.
Action:
Run the NETCONFIG program to search
for another Ethernet controller
Verify that the Ethernet controller is
enabled. If the Ethernet controller is
enabled, run the diagnostic programs.
pnt0-6 Cannot allocate memory for the adapter
during an interrupt. Please check the
Streams parameters.
Explanation: On a SunSoft Solaris system,
this message indicates that the system is out of
Streams memory blocks.
Action: Use the CRASH utility to increase the
number of Streams memory blocks. Modify the
interrupt request (IRQ) settings in the
Configuration/Setup Utility program, or run the
NETCONFIG program to match the hardware
settings.
pnt0-7 Cannot allocate memory for the adapter
during reset. Please check the Streams
parameters.
Explanation: The system is out of Streams
memory blocks.
Action: Use the CRASH utility to increase the
number of Streams memory blocks.
Table 4. NDIS (Windows NT) driver messages for the
Ethernet controller