IBM 31Y Security Camera User Manual


 
Diagnostics 29
pnt0-11 Device not found!
Explanation: The driver cannot find an
Ethernet controller.
Action: Verify that the Ethernet controller is
enabled. If the Ethernet controller is enabled,
run the diagnostic programs.
pnt0-12 Device failed checksum test!
Explanation: The driver cannot find an
Ethernet controller.
Action: Verify that the Ethernet controller is
enabled. If the Ethernet controller is enabled,
run the diagnostic programs.
pnt0-13 add_intr_handler failed! Interrupts already
enabled.
Explanation: The interrupt request (IRQ) that
was specified, or the IRQ that was found,
conflicts with other devices in the server.
Action: Modify the hardware settings.
pnt0-14 Cannot locate hardware.
Explanation: The SunSoft Solaris driver
cannot find any Ethernet controller.
Action: Verify that the Ethernet controller is
enabled. If the Ethernet controller is enabled,
run the diagnostic programs.
pnt0-15 No more devices to open.
Explanation: The SunSoft Solaris driver
cannot find any more Ethernet controllers.
Action: Verify that additional IBM Netfinity
10/100 Fault Tolerant Adapters are present or
replace the Ethernet adapter that fails to
respond. If the problem persists, run the
diagnostic programs.
pnt0-17 Device fault...Reset initiated!
Explanation: The SunSoft Solaris driver has
been reset due to a device fault.
Action: Verify that additional IBM Netfinity
10/100 Fault Tolerant Adapters are present or
replace the Ethernet adapter that fails to
respond. If the problem persists, run the
diagnostic programs.
Table 5. UNIX LLI driver messages for the Ethernet
controller