Filter
Top Products
Note: You can only adjust a paused image; adjustment of footage during playback is too CPU
intensive. Any adjustment you have made will be reapplied when footage is paused again.
Using Markers to Create a Sub-Range 1.3.10
During playback, if only a sub-section of the loaded footage is of interest, it can quickly be selected by using
“Markers”. To use markers, select the “Markers” tab from the “Advanced Features” section.
Position the footage navigation slider at the beginning of the desired footage and click the “Start Range”
button. You will notice a small marker appear below the starting point. Next, navigate to the end of the
desired footage and click the “End Range” button.
When you are ready, click the “View” button to display the marked footage. The playback information will
indicate that a sub-range is currently displayed. All of the playback controls will operate on only the sub-
range of footage.
If you are playing footage in multi-screen mode, each camera can have a different sub-range marked and
displayed, independent of the other cameras.
When exporting footage, only the sub-range will be saved.
Note: To export a sub-range, you must have clicked the “View” button; otherwise, the entire
footage will be exported.
To return to the full footage, click the “View” button again or “Clear” to remove the markers.
Audio Playback 1.3.11
If audio hardware is enabled for your DVR, you can also have recorded audio play back at the same time as
video footage. To control audio playback, select the “Audio” tab from the “Advanced Features” section.
3xLogic Vigil System Server Software - User’s Guide Doc# 08100610 Page 33