Filter
Top Products
D 14049.01
07.2007
114
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Bandwidth Control
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Bandwidth
Control
It is possible to control the amount of
bandwidth used on calls between specific
subzones and zones. The limits can be
applied to the total concurrent bandwidth used
at any one time, or to the bandwidth used by
any individual call.
To apply these limits, you create a pipe and
configure it with the required bandwidth
limitations. You then assign the pipe to a
link. Calls using the link will then have those
bandwidth limitations applied to them.
Creating Pipes
Name
Enter the name you wish to give to this pipe.
You will refer to this name when creating links.
Create Pipe
Click here to create the pipe and return to the
Pipes page.
About Pipes
Creating a new pipe
To create a pipe:
VCS Configuration > Bandwidth > Pipes.
You will be taken to the Pipes page.
Select New.
You will be taken to the Create Pipe page.
xCommand PipeAdd
•
•
Total bandwidth mode
Determines whether there is a limit on the
total concurrent bandwidth of this pipe.
Unlimited: no limitations are in place.
Limited: there is a limit in place; you must
enter the limit in the field below.
None: there is no bandwidth available.
Total bandwidth (kbps)
Sets the limit on the total concurrent
bandwidth of this pipe.
Per call bandwidth mode
Determines whether there is a limit on the
bandwidth of individual calls via this pipe.
Unlimited: no limitations are in place.
Limited: there is a limit in place; you must
enter the limit in the field below.
None: there is no bandwidth available.
Per call bandwidth (kbps)
Sets the limit on the bandwidth of individual
calls via this pipe.
Bandwidth Control