TANDBERG D14049.01 Security Camera User Manual


  Open as PDF
of 187
 
D 14049.01
07.2007
154
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xCommand
xCommand Description Parameters
SubZoneAdd
Adds and congures a new subzone.
SubZoneName(r): <S: 1, 50>
Assigns a name to this subzone.
Address: <S: 0, 39>
Species an IP address used (in conjunction with the IP Prex Length) to identify a subnet to be assigned to this subzone.
PrexLength: <0..128>
Species the number of bits of the Subnet IP address which must match for an IP address to belong in this subzone.
TotalMode: <None/Limited/Unlimited>
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any one time.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if Mode is set to Limited).
PerCallInterMode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
PerCallInter: <1..100000000>
Species the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set
to Limited).
PerCallIntraMode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
PerCallIntra: <1..100000000>
Species the bandwidth limit (in kbps) on any one call between two endpoints within this subzone.
SubZoneDelete
Deletes a subzone.
SubZoneId(r): <1..100>
The index of the subzone to be deleted.
 previous next