TANDBERG D14049.01 Security Camera User Manual


  Open as PDF
of 187
 
D 14049.01
07.2007
149
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xCommand
xCommand Description Parameters
AllowListAdd
Adds an entry to the Allow List.
PatternString(r): <S: 1, 60>
Species an entry to be added to the Allow List. If one of an endpoint’s aliases matches one of the patterns in the Allow
List, the registration will be permitted.
PatternType: <Exact/Prex/Sufx/Regex>
Species whether the entry in the Allow List is a prex, sufx, regular expression, or must be matched exactly.
AllowListDelete
Deletes an entry from the Allow List.
AllowListId(r): <1..2500>
The index of the entry to be deleted.
Boot
Reboots the VCS. none
CheckBandwidth
A diagnostic tool that returns the status and route (as a list
of nodes and links) that a call of the specied type and band-
width would take between two nodes.
Note that this command does not change any existing system
conguration.
Node1(r): <S: 1, 50>
The subzone or zone from which the call originates.
Node2(r): <S: 1, 50>
The subzone or zone at which the call terminates.
Bandwidth(r): <1..100000000>
The requested bandwidth of the call (in kbps).
CallType(r): <Traversal/NonTraversal>
Whether the call type is Traversal or Non Traversal.
CheckPattern
A diagnostic tool that allows you to check the result of an
alias transform (local or zone) before you congure it on the
system. Note that this command does not change any existing
system conguration.
Target(r): <S: 1, 60>
The original alias.
Pattern(r): <S: 1, 60>
The pattern against which the alias is to be compared.
Type(r): <Exact/Prex/Sufx/Regex>
The way in which the pattern must match the alias in order for the transform to be applied.
Behavior(r): <Strip/Replace>
The way in which the alias will be modied.
Replace: <S: 1, 60>
(Applies only if Behavior is set to Replace.)
The string to be substituted for the part of the alias that matched the pattern.
 previous next