Filter
Top Products
D 14049.01
07.2007
143
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xConguration
Zones
cont...
LocalZone
cont...
Traversal
cont...
H323
cont...
Preference: <Assent/H46018>
If an endpoint that is registered directly with the VCS supports both Assent and H.460.18 protocols, this setting
determines which the VCS uses.
Assent: the Assent protocol will be used.
H46018: the H.460.18 protocol will be used.
TCPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered
directly with the VCS will send a TCP probe to the VCS once a call is established, in
order to keep the rewall’s NAT bindings open.
RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the
VCS will attempt to send a TCP probe to the VCS.
RetryInterval: <1..65534>
Sets the frequency (in seconds ) with which traversal-enabled endpoints registered
directly with the VCS will send a TCP probe to the VCS.
UDPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered
directly with the VCS will send a UDP probe to the VCS once a call is established,
in order to keep the rewall’s NAT bindings open.
RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the
VCS will attempt to send a UDP probe to the VCS.
RetryInterval: <1..65534>
Sets the frequency (in seconds ) with which traversal-enabled endpoints registered
directly with the VCS will send a UDP probe to the VCS.