Filter
Top Products
D 14049.01
07.2007
24
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
text
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
System
Configuration
About SNMP Settings
The VCS offers basic support for SNMP.
Tools such as TANDBERG Management Suite
(TMS) or HP OpenView may act as SNMP
network management systems (NMS). They
allow you to monitor your network devices,
including the VCS, for conditions that might
require administrative attention.
To allow the VCS to be monitored by a SNMP
NMS, you must enable SNMP on the VCS and
provide the name of the SNMP community
within which it resides. You may optionally
provide the name of a System contact and the
physical Location of the system for reference
by administrators when following up on
queries.
By default, SNMP is Enabled with a SNMP
community name of public.
Note: the VCS does not support SNMP traps,
therefore it cannot be managed via SNMP.
SNMP Configuration
System Conguration
Configuring SNMP Settings
To configure the VCS’s SNMP settings:
System Configuration > SNMP
You will be taken to the SNMP page.
xConfiguration SNMP
•
•
Location
Specifies the physical location of the VCS.
Enabled
Select On to enable SNMP support.
SNMP community name
Sets the VCS’s SNMP community name.
System contact
Specifies the name of the person who can be
contacted regarding issues with the VCS.
Save
Click here to save your changes.
Restart
Click here to restart the system.
You must save your changes and
restart the system for any changes to
take effect.