Filter
Top Products
D 14049.01
07.2007
63
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Call
Processing
Administrator Policy
About Administrator Policy
The VCS allows you to set up a set of rules to control which calls are allowed, which are rejected,
and which are to be redirected to a different destination. These rules are known as Administrator
Policy.
If Administrator Policy is enabled and has been configured, each time a call is made the VCS will
execute the policy in order to decide, based on the source and destination of the call, whether to
proxy the call to its original destination
redirect the call to a different destination
reject the call.
You can set up an Administrator Policy in either of two ways:
by configuring basic administrator policy using the web interface. (Note that this will only allow
you to Allow or Reject specified calls)
by uploading a script written in the Call Processing Language (CPL).
•
•
•
•
•
Administrator Policy and Authentication
Administrator Policy uses the source and destination of a call to determine the action to be taken.
Policy interacts with Authentication when considering the source alias of the call. If your VCS is
part of a secure environment, any policy decisions based on the source of the call should only be
made when that source can be authenticated. Whether or not the VCS considers an endpoint to
be authenticated depends on the Authentication Mode setting of the VCS.
Authentication Mode On
When Authentication Mode is set to On on the VCS, all endpoints and neighbors are required to
authenticate with it before calls will be accepted. In this situation, the VCS acts as follows:
An endpoint is considered to be authenticated when:
it is a locally registered endpoint. (Because Authentication Mode is On, the registration will
have been accepted only after the endpoint authenticated successfully with the VCS.)
it is a remote endpoint that is registered to and authenticated with a Neighbor VCS, and that
Neighbor in turn has authenticated with the local VCS.
An endpoint is considered to be unauthenticated when:
it is a remote endpoint registered to a neighbor and that neighbor has not authenticated with
the VCS. This is regardless of whether or not the endpoint authenticated with the neighbor.
If a call is received from an unauthenticated neighbor or endpoint the call’s source aliases will be
removed from the call request and replaced with an empty field before the Administrator Policy
is executed. This is because there is a possibility that the source aliases could be forged and
therefore they should not be used for policy decisions in a secure environment. This means that,
when Authentication Mode is On and you configure policy based on the source alias, it will only
apply to authenticated sources.
Authentication Mode Off
When Authentication Mode is set to Off on the VCS, calls will be accepted from any endpoint or
neighbor. The assumption is that the source alias is trusted, so authentication is not required.
•
•
•
Overview
Only one of these two methods can be used at any one time to specify Administrator
Policy. If a CPL script has been uploaded, this will disable use of the web interface to
configure administrator policy. In order to use the web interface, you must delete the CPL
script that has been uploaded.
Use Administrator Policy to determine which callers can make or receive calls via the VCS.
Use Allow and Deny lists to determine which aliases can or cannot register with the VCS.
When enabled, Administrator Policy is executed for all calls going through the VCS.